FPS Slip Ring Series

FPS can reach up to 500 rpm and is based on a double ball bearing system. The rings terminal board based on threaded rods with nuts directly welded on the rings, ensure safe and reliable wiring even at high speed.

FPS has an expected lifetime of up to 500 million revolutions. Proper maintenance is essential to reach the highest possible lifetime.

Serviceability is a huge plus of FPS. FPS has an easy access to the wiring and cleaning area. By simply removing the four screws of the cover, you have full access to the slip ring. The cover is keeping the wear dust in its lower part and removing it, the slip rings can be easily cleaned from possible residual dust which could remain on rings and insulators. If you prefer to remove the slip ring from the machine without opening it to perform the cleaning in another area of your plant to avoid any risk of contamination, an option with a separate chamber for wiring is available. With this option you can easily disconnect the slip ring from your machine, without opening the sliding contact section, then you can fully access it in a second step for perfect and safe cleaning.

FPS has an easy installation on the rotating shaft of the machine, simply done with three socket set screws on the hub and an anti-rotation slot integrated in the slip ring external body. The wiring is extremely easy with a terminal board on rings based on threaded rods with nuts and fast-on connection on brushes side. Optionally a Spring Terminals connection is available on the brushes side.